NEC Univerge sv8500 Manual page 1174

21. SET SUBSCRIBE_RETRY
Select the regeneration mode for SIP SUBSCRIBE session.
MG-BRI(SIP)> SET SUBSCRIBE_RETRY P1
SIP Subscribe Retry setting succeeded.
In order to make a setup reflect. re-starting is
required after saving a configuration data
by SAVE command.
Execute the "SAVE" command before finishing the maintenance command to reflect change.
Note:
22. SET VLAN
Assign the Tag VLAN information.
MG-BRI(SIP)> SET VLAN
VLAN_ID(0-4094):1
COS(0-7):6
IP Address:10.41.1.200
Subnet mask:255.255.255.0
VLAN setting succeeded.
In order to make a setup reflect. re-starting is
required after saving a configuration data
by SAVE command.
A maximum one of VLAN can be registered.
Note:
When using VLAN, assign "0.0.0.0" for IP address of actual LAN by using "SET OWN_IPADDRESS"
Note:
command.
Do not assign the following addresses (network address, broadcast address) to MG(BRI).
Note:
(example)
- IP address 192.168.1.0/Subnet mask 255.255.255.0 (192.168.1.0 is network address, improper)
- IP address 176.16.0.0/Subnet mask 255.255.0.0 (176.16.0.0 is network address, improper)
- IP address 192.168.1.255/Subnet mask 255.255.255.0 (192.168.1.255 is broadcast address, improper)
- IP address 176.16.255.255/Subnet mask 255.255.0.0 (176.16.255.255 is broadcast address, improper)
Execute the "SAVE" command before finishing the maintenance command to reflect change.
Note:
If "0" is assigned for VLAN ID, VLAN will be unavailable.
Note:
VOL.2-921
MG(BRI) [SCA-2BRIA/MG-2BRIA]
P1: ENABLE / DISABLE
ENABLE=Session is regenerated.
DISABLE=Session is not regener-
ated (default)
The result is shown.
VLAN ID: 0-4094 (default: 0)
CoS setting: 0-7
IP address of VLAN
Subnet mask of VLAN
The result is shown.