NEC Univerge sv8500 Manual page 1166

4. SET DNS_IPADDRESS
Assign the IP Address of DNS server.
MG-BRI(SIP)>
SET DNS_IPADDRESS
DNS IP address setting succeeded.
In order to make a setup reflect. re-starting is
required after saving a configuration data
by SAVE command.
Enter 0.0.0.0 when DNS server is not used.
Note:
Execute the "SAVE" command before finishing the maintenance command to reflect change.
Note:
5. SET DNS_SV
Assign whether to use DNS server or not.
MG-BRI(SIP)> SET DNS_SV
DNS setting succeeded.
In order to make a setup reflect. re-starting is
required after saving a configuration data
by SAVE command.
Execute the "SAVE" command before finishing the maintenance command to reflect change.
Note:
6. SET DTMF_IN
Assign whether Inband DTMF is used or not.
MG-BRI(SIP)>
SET DTMF_IN
Inband DTMF Relay setting succeeded.
In order to make a setup reflect. re-starting is
required after saving a configuration data
by SAVE command.
Execute the "SAVE" command before finishing the maintenance command to reflect change.
Note:
Inband DTMF Relay is valid only when G.711 is used as CODEC for voice communication. Pay attention
Note:
to the CODEC settings because the Inband DTMF Relay does not identify the type of CODEC.
P1
P1
P1
VOL.2-913
MG(BRI) [SCA-2BRIA/MG-2BRIA]
P1: IP address of DNS server
(default: 0.0.0.0)
The result is shown.
P1: ENABLE / DISABLE
ENABLE: Using DNS server
DISABLE: Not using DNS server
(default: DISABLE)
P1: ON / OFF
ON=In-band DTMF is valid
OFF=In-band DTMF is invalid
(default)
The result is shown.