NEC Univerge sv8500 Manual page 1182

SAVE CONFIG, INIT CONFIG, EXIT, REBOOT Command
SAVE CONFIG
This command is used to save the modified configuration data to the FlashROM.
MG-BRI(SIP)> SAVE CONFIG
** Don't power off in progress **
Do you need save? [Y/N]: Y
Configuration data has been saved.
Re-starting is required for making a setup reflect!!
Configuration data will not be saved when any error occurs while SAVE CONFIG command is in process.
Note:
INIT CONFIG
This command is used to initialize the configuration data to factory default value.
MG-BRI(SIP)> INIT CONFIG
*** Warning !! ***
This command initializes the configuration data.
This deletes the current setting.
Recommend to back up the setting.
Command execute or not? (Y/N) : Y
It's recommended to back up your configuration !!
really OK ? (Y/N) : Y
Initialize of configuration data was successful.
You need to setup MGBRI's config data!!
MC(SIP)>
Use this command only when required to initialize all the configuration data to factory default value.
Note:
VOL.2-929
MG(BRI) [SCA-2BRIA/MG-2BRIA]
Enter "Y" to execute data saving.
Result is displayed.
Asked whether to execute
initialization.
Y=Initialize
N=Not execute
Asked again for confirmation.
Y=Initialize
N=Not execute
Result is displayed.