NEC Univerge sv8500 Manual page 1169

IP Address setting succeeded.
In order to make a setup reflect. re-starting is
required after saving a configuration data
by SAVE command.
Assign the IP Address first, then Subnet Mask.
Note:
Execute the "SAVE" command before finishing the maintenance command to reflect change.
Note:
Do not assign the following addresses (network address, broadcast address) to MG(BRI).
Note:
(example)
- IP address 192.168.1.0/Subnet mask 255.255.255.0 (192.168.1.0 is network address, improper)
- IP address 176.16.0.0/Subnet mask 255.255.0.0 (176.16.0.0 is network address, improper)
- IP address 192.168.1.255/Subnet mask 255.255.255.0 (192.168.1.255 is broadcast address, improper)
- IP address 176.16.255.255/Subnet mask 255.255.0.0 (176.16.255.255 is broadcast address, improper)
13. SET RTP_START_PORT_NO
Specify the first port number to be used for RTP.
SET RTP_START_PORT_NO P1
MG-BRI(SIP)>
RTP Start Port Number setting succeeded.
In order to make a setup reflect. re-starting is
required after saving a configuration data
by SAVE command.
Execute the "SAVE" command before finishing the maintenance command to reflect change.
Note:
Assign any even-numbered port number to the RTP start port. The specified data + 1 (the next odd-num-
Note:
bered port number) is automatically assigned as the RTCP port number.
24 ports are occupied following the RTP start port. More than 24 of consecutive vacant ports must be re-
Note:
served from the specified port number to the last 65535.
14. SET RTP_STOP_DETECT
Specify a time-out value for MG Based Call Retention
SET RTP_STOP_DETECT P1
MG-BRI(SIP)>
RTP Stop Detect Timer setting succeeded.
In order to make a setup reflect. re-starting is
required after saving a configuration data
by SAVE command.
.
VOL.2-916
MG(BRI) [SCA-2BRIA/MG-2BRIA]
The result is shown.
P1: Port number (1024-65512)
(default: 1024)
The result is shown.
P1: Time-out value for RTP recep-
tion. (one second interval)
3-32 seconds (default: 3 sec-
onds)=Effective range
The result is shown.