NEC Univerge sv8500 Manual page 1028

• When P1 and P2 is not specified (Dialogue type entry: When IP Precedence was selected)
MG-BRI>set signaling_qos
QOS[I(IP PRECEDENCE)/D(DIFFSERV):I]:I
PRECEDENCE(0-7:6):6
DELAY(0/1:0):0
THROUGHPUT(0/1:0):0
RELIABILITY(0/1:0):0
COST(0/1:0):0
Meaning of ToS field for IP Precedence type is as follows.
Note:
ToS field value:
• Prec.= PRECEDENCE (3bits)
• D = Delay (1bit)
• T = Throughput (1bit)
• R = Reliability (1bit)
• C = Cost (1bit)
• - = Not used
• When P1 and P2 is not specified (Dialogue type entry: When Diffserv was selected)
MG-BRI>set signaling_qos
QOS[I(IP PRECEDENCE)/D(DIFFSERV):I]:D
DSCP(0-63:48):46
Meaning of ToS field for Diffserv type is as follows.
Note:
ToS field value:
Execute the "SAVE" command before finishing the maintenance command to reflect change.
Note:
b7 b6 b5 b4 b3
Prec D T
b7 b6 b5 b4 b3
DSCP
P1: I/D/C
I: When (IP PRECEDENCE) was selected
Precedence within the IP Network (0-7) (Default: 6)
Order to prioritize Low delay within the IP Network
0: No order (Default)
1: Order
Order to prioritize Throughput within the IP Network
0: No order (Default)
1: Order
Order to prioritize Reliability within the IP Network
0: No order (Default)
1: Order
Order to prioritize Lower cost within the IP Network
0: No order (Default)
1: Order
b2 b1 b0
R C -
P1: I/D/C
D: When (Diffserv) was selected.
b2 b1 b0
-
VOL.2-775
MG-BRI