NEC Univerge sv8500 Manual page 1112

DELAY(0/1): 0
THROUGHPUT(0/1: 0):0
RELIABILITY(0/1: 0):0
COST(0/1:0):0
Signaling QoS setting succeeded.(0xC0)
The result of data setting is shown in a 1-byte (hexadecimal) format in accordance with the setting dialog
Note:
followed by the prompt. The meaning of 1-byte data is shown below:
Prec.
D T R C
Precedence of Low Delay in IP network
0: Not specified (Default)
1: Specified
Precedence of Throughput in IP network
0: Not specified (Default)
1: Specified
Precedence of Reliability in IP network
0: Not specified (Default)
1: Specified
Precedence of Lower Cost in IP network
0: Not specified (Default)
1: Specified
The result is displayed.
Prec.=PRECEDENCE (3 bits)
D=Delay
T=Throughput
R=Reliability
C=Cost
VOL.2-859
MG(BRI) [SCA-2BRIA/MG-2BRIA]