NEC Univerge sv8500 Manual page 1157

12.4.8 Maintenance Command (SP-3826 BRI MG SIP BSC PROG-A Issue 5.0 or later)
SETUP COMMAND
Set the basic data for connecting network by "SETUP SP" command depending on your LAN environment. En-
ter "SETUP SP" following the prompt.
To startup SETUP SP:
MG-BRI(SIP)> SETUP SP
Setting DHCP server enable/disable:
--- DHCP Interface set ---
Current DHCP Interface: ENABLE
Change DHCP Interface? [Y(change)/
N(current)/Q(quit)]: Y
Input new DHCP Interface [E(enable)/
D(disable)]: D
Setting DNS server enable/disable:
--- DNS Interface set ---
Current DNS Interface: DISABLE
Change DNS Interface? [Y(change)/
N(current)/Q(quit)]: Y
Input new DNS Interface [E(enable)/
D(disable)]: E
Enter "SETUP SP" following the prompt.
The current setting is displayed.
Asked whether to change the displayed setting.
Y=change
N=not change
Q=quit this setting
Specify whether to use DHCP server.
E=Use DHCP server
D=Not use DHCP server (default)
The current setting is displayed.
Asked whether to change the displayed setting.
Y=change
N=not change
Q=quit this setting
Specify whether to use DNS server.
E=Use DNS server
D=Not use DNS server (default)
VOL.2-904
MG(BRI) [SCA-2BRIA/MG-2BRIA]