NEC Univerge sv8500 Manual page 1214

13.4 Operation and Maintenance
13.4.1 How to Use Maintenance Command
"DRS (Device Registration Server)" used in this section refers to the Telephony Server. The Telephony
Note:
Server acts as DRS, where MG-PRI/PRA is registered.
When an event causing a restart of the device, such as health check timeout, occurs during startup of the
Note:
configuration command, it takes about five minutes to start the rebooting after you exit from the configu-
ration command or enter the last command.
1. Connect a PC to the MG-PRI/PRA using the RS-232C straight-through cable and run terminal software
(e.g. HyperTerminal) on the PC.
2. Set the parameter of the terminal software as follows:
• Port: COM1
• Baud Rate: 9600 bps
• Data: 8 bits
• Parity: None
• Stop Bit: 1
• Flow Control: None
3. Enter usrConsole after the prompt. Then the following prompt appears.
MG-PRI>_ (Machine Name > : default)
An example of indication is shown below:
The user input command above consists of a several components. The following describes these components
using one of the set commands.
MG-PRI> set ipaddress 123.50.18.45
IP Address has set
MG-PRI>_
VOL.2-961
MG
to serial port
Tx/Rx LINK
ON MUSIC
PWR LINE -LINE- LB
B D
TNS RCV 10/100
IMP
MG-2M
LINE
maintenance console
User Input Command
Reply Message
Prompt
MG-PRI/PRA