NEC Univerge sv8500 Manual page 1258

13.4.10 EXIT Command
1. EXIT
This command is used to exit the program.
COMMAND 1 (Normal)
MG-PRI > EXIT
>
COMMAND 2
(When both configuration data for NC and TC are modified but not saved)
MG-PRI > EXIT
Configuration data for NC was changed.
** Don't power off in progress **
y: Save and Exit.
n: Exit without saving.
c: Cancel
[y/n/c]:y
Configuration data for NC has been saved.
Configuration data for TC was changed.
** Don't power in progress **
y: Save and Exit.
n: Exit without saving.
c: Cancel
[y/n/c]:y
Configuration data for TC has been saved.
COMMAND 3
(When either configuration data for NC or TC is modified but not saved)
MG-PRI > EXIT
Configuration data for NC was changed.
**Don't power off in progress **
y: Save and Exit.
n: Exit without saving.
c: Cancel
[y/n/c]:y
Configuration data for NC has been saved.
If "exit" command is executed at OS(MG-PRI/PRA) prompt, any key entry will not be effective. In this case,
Note:
press "Ctrl" and "C" together to redisplay OS prompts.
COMMAND 2 and 3
1) Determine the following:
y=Save the file and exit the program
n=Exit the command without saving
c=Cancel the command
A command is executed, and the result is displayed.
VOL.2-1005
MG-PRI/PRA