NEC Univerge sv8500 Manual page 1163

RELIABILITY(0/1: 0):0
COST(0/1:0):0
The result of data setting is shown in a 1-byte (hexadecimal) format in accordance with the setting dialog
Note:
followed by the prompt. The meaning of 1-byte data is shown below:
Prec.
When D: DIFFSERV is selected:
QoS [I (IP PRECEDENCE)/D (DIFFSERV): IP PRECEDENCE]:d
DSCP (0-63: 48): 48
The result of data setting is shown in a 1-byte (hexadecimal) format in accordance with the setting dialog
Note:
followed by the prompt. The meaning of 1-byte data is shown below:
DSCP
VLAN Information set
Assign the VLAN data.
--- VLAN Information set ---
Current VLAN Information:
Device
VLAN 1
Change VLAN Information? [Y (change)/N (current)/
Q(quit)]: y
Input new VLAN ID (0-4094): 1
Input new COS (0-7): 6
Input new IP Address: 10.41.1.200
Input new Subnet mask: 255.255.255.0
D T R C
ID COS IP Address
1 7 10.41.1.200
Precedence of Reliability in IP network
0: Not specified (Default)
1: Specified
Precedence of Lower Cost in IP network
0: Not specified (Default)
1: Specified
Prec.=PRECEDENCE (3 bits)
D=Delay
T=Throughput
R=Reliability
C=Cost
Enter DSCP value (0-63)
(Default: 48)
DSCP = Differentiated Service Code Point (6 bits)
Current data setting is displayed.
Subnetmask
255.255.255.0
Asked whether to change the displayed data.
Y: To change the displayed data
N: Not change
Q: Quit Standard mode
VLAN ID: 0-4094
CoS setting: 0-7
Enter the IP address of VLAN.
Enter the subnet mask of VLAN.
VOL.2-910
MG(BRI) [SCA-2BRIA/MG-2BRIA]