NEC Univerge sv8500 Manual page 1222

Δ Δ
6. SET DRSQOS [P1]
This command is used to specify Quality of Service (QOS) such as IP Precedence and Differentiated Ser-
vice (DIFFSERV) for DRS. To make this assignment effective, it is required to execute the "SAVE" com-
mand and to restart before exiting the maintenance command.
COMMAND 1
MG-PRI > SET DRSQOS
QOS (TOS/DIFFSERV:TOS):TOS
PRECEDENCE (0-7:0):6
DELAY (0/1:0):0
THROUGHPUT (0/1:0):0
RELIABILITY(0/1:0):0
COST (0/1:0):0
DRS QoS setting succeeded. (0xC0)
In order to make a setup reflect, re-starting
is required after saving a configuration file
by SAVE command.
COMMAND 2
MG-PRI > SET DRSQOS
QOS (TOS/DIFFSERV:TOS):DIFFSERV
DSCP(0-63:0):48
DRS QoS setting succeeded. (0xC0)
In order to make a setup reflect, re-starting
is required after saving a configuration file
by SAVE command.
COMMAND 3
MG-PRI > SET DRSQOS TOS 0xC0
DRS QoS setting succeeded. (0xC0)
In order to make a setup reflect, re-starting
is required after saving a configuration file
by SAVE command.
COMMAND 4
MG-PRI > SET DRSQOS DIFFSERV 48
DRS QoS setting succeeded. (0xC0)
In order to make a setup reflect, re-starting
is required after saving a configuration file
by SAVE command.
COMMAND 5
MG-PRI > SET DRSQOS CLEAR
DRS QoS clearing succeeded. (0x00)
In order to make a setup reflect, re-starting
is required after saving a configuration file
by SAVE command.
Δ
[P2]
VOL.2-969
P1-Specify a type of services
TOS: IP Precedence
DIFFSERV: Differentiated Service
CLEAR: Clear the data
P2-Specify a value
00-FF (In the case of TOS)
0-63 (In the case of DIFFSERV)
When selecting TOS and omitting P2
→ COMMAND 1
When selecting DIFFSERV and omitting in P2
→ COMMAND 2
When specifying TOS in P1 and a parameter in P2
→ COMMAND 3
When specifying DIFFSERV in P1 and a parameter in
P2
→ COMMAND 4
When selecting CLEAR in P1
→ COMMAND 5
<COMMAND 1>
1) Specify TOS for QOS
2) Specify precedence (Default: 6)
0-7 (low-high)
3) Select a type of delay (Default: 1)
0/1=Normal/Delay
4) Select a type of throughput (Default: 1)
0/1=Normal/High Throughput
5) Select a type of reliability (Default: 0)
0/1=Normal/High Reliability
6) Select a type of cost (Default: 0)
0/1=Normal/Cost Precedence
A command is executed, and the result is displayed.
<COMMAND 2>
1) Specify DIFFSERV for QOS
2) Specify Diffserv Codepoint (DSCP)
0-63=DSCP
A command is executed, and the result is displayed.
<COMMAND 3-5>
A command is executed, and the result is displayed.
MG-PRI/PRA