NEC Univerge sv8500 Manual page 1198

13.3 System Startup
13.3.1 Summary
After completing hardware settings on the previous page, the setup procedures as follows are taken. These set-
tings are divided into three parts: the settings of the Telephony Server and the settings of MG-PRI/PRA, and
connection check. To set up the MG-PRI/PRA, these procedures are necessary to proceed.
13.3.2 Before Taking Procedures
Before taking procedures, please take the following:
• Connect the maintenance console by using an RS-232C straight-through cable.
• Unstable network environment such as using NAT and dial-up connection is not preferred
• Connecting ISDN is applied for not tie network but PSTN using the following protocol:
- North America: Bellcore NI-2 AT&T NO5ESS DMS-100
- Other Countries: ETSI ETS300.102.1
• The following provides the port number to be used in this system. If a firewall is used in your network, do
not block the following ports.
PORT NO.
64000 ∼ 65024 PHI-PRI
PRI/PRA
7500 PHI-PRI
PRI/PRA
∼
1024 Peer to Peer
1024 ∼ 2048 Peer to Peer
3456 MG-PRI/
PRA ↔
10001
PATH FUNCTION
→ MG-
iLP-PM
← MG-
H.245
RTP
Registration
DRS
Preparation for H.245 is
completed.
VOL.2-945
NOTE
Changed by using PCPro belonging to the
Telephony Server. (ADTM)
The initial value can be changed by using
a local console.
Allocated by Operating System.
The initial value can be changed by using
a local console.
The initial value can be changed by using
a local console.
The initial value can be changed by using
a local console.
MG-PRI/PRA