NEC Univerge sv8500 Manual page 1143

7. SET INTERFACE
Assign the speed and activation mode of Ether controller.
MG-BRI > set interface
SPEED [1(AUTO)/2(100M)/3(10M)]: 1
Default configuration is 'AUTO',
if you will not change a configuration by using this command.
In order to make a setup reflect and keep, re-starting is
required after saving a configuration data by SAVE command.
DUPLEX setting is displayed when SPEED "2: 100M" or "3: 10M" is selected.
Note:
F (full) = Full-duplex mode
H (half) = Half-duplex mode
Assign the proper speed adjusting the network devices (router, HUB) on the destination.
Note:
Execute the "SAVE" command before finishing the maintenance command to reflect change.
Note:
8. SET LAN_ERROR_CHECK
Assign the interval to detect LAN cable fall-off
MG-BRI> set lan_error_check
LAN Error Check Timer (100-1000/10): 1000
Default configuration is '1000',
if you will not change a configuration by using this command.
In order to make a setup reflect and keep, re-starting is
required after saving a configuration data by SAVE command.
Execute the "SAVE" command before finishing the maintenance command to reflect change.
Note:
9. SET ONE_TIME_PASS
Assign the one time password to be used for the first registration after connected to network.
MG-BRI> set one_time_pass
One Time Password: 1234
Default configuration is 'blank',
if you will not change a configuration by using this command.
In order to make a setup reflect and keep, re-starting is
required after saving a configuration data by SAVE command.
Execute the "SAVE" command before finishing the maintenance command to reflect change.
Note:
VOL.2-890
MG(BRI) [SCA-2BRIA/MG-2BRIA]
AUTO: AUTO Negotiation (default)
100M: 100Mbps Fixed mode
10M: 10Mbps Fixed mode
Effective ran
ge: 100-1000 in 10-msec
)
step (default: 1000
Enter any password in 4~10 characters.
(available characters are 0-9, *, # only)