NEC Univerge sv8500 Manual page 1096

Activate HyperTerminal and set the following:
STEP 9
Bit per second: 9600bps
Data bits: 8bit
Parity: None
Stop bit:1bit
Flow control: None
Reboot MG(BRI) (OFF->ON).
STEP 10
Connect AC adapter to MG(BRI) (or turn on the switch).
STEP 11
When the message "Starting MG(BRI) boot program..." appears, press ESC key within 5 sec-
STEP 12
onds.
Enter "cmd" for Input.
STEP 13
Enter "ipxadmin" for password.
STEP 14
After a prompt (>>>Set command :) is displayed, enter "download".
STEP 15
The File Download mode is displayed. Input "3" (Download of Tone payload data).
STEP 16
Enter the Downloading file name and Tone data area number.
STEP 17
Confirm the entered download file name and Tone data area number. If they are correct, input
STEP 18
"y".
Input "n" (set the existing IP address) for MG(BRI)'s IP address set, if the default IP address
STEP 19
is not correct, input "y" and enter the proper IP address.
Input "n" (set the existing IP address) for TFTP's IP address set, if the default IP address is
STEP 20
not correct, input "y" and enter the proper IP address.
Make sure correct IP addresses are set in TFTP server and MG(BRI). And then input "y" if
STEP 21
they are correct.
After all the download is completed, enter "q" to reboot the system. If other tone data is re-
STEP 22
quired, enter "3" and back to Tone downloading display.
Tone data can be downloaded a maximum of 3 files.
Note:
<Confirmation of MG(BRI) Operation>
Connect the MG(BRI) to a network, and reboot MG(BRI).
STEP 23
To confirm MG(BRI) Tone data is downloaded correctly, check the status of setting, and con-
STEP 24
firm the SM number of Tone information on screen.
VOL.2-843
MG(BRI) [SCA-2BRIA/MG-2BRIA]