NEC Univerge sv8500 Manual page 919

->usrConsole
MG-COT Maintenance command
MG-COT>
STEP 4: Set the basic data for connecting network by "SETUP SP" command depending on your LAN envi-
ronment. Enter "SETUP SP" following the prompt.
MG-COT>
MG-COT>SETUP SP
STEP 5: Assign whether to use DHCP server and DNS server. The required setting differs whether to use each
server first.
DHCP server enable/disable setting:
--- DHCP Interface set ---
Current DHCP Interface : ENABLE
Change DHCP Interface ? [Y(change)/N(current)/Q(quit)] : Y
Input new DHCP Interface [E(enable)/D(disable)] : D
DNS server enable/disable setting:
--- DNS Interface set ---
Current DNS Interface : DISABLE
Change DNS Interface ? [Y(change)/N(current)/Q(quit)] : Y
Input new DNS Interface [E(enable)/D(disable)] : E
--- DNS Interface set ---
STEP 6: Assign network data according to the setting of DHCP server and DNS server;
• When DHCP server is used
• When DHCP server is NOT used & DNS server is used
• When DHCP server is NOT used & DNS server is NOT used
VOL.2-666
MG-COT Card [SCA-6COTB]