NEC Univerge sv8500 Manual page 1242

Δ Δ
28. SET TCS_T1_3
This command is used to specify T1 data. To make this assignment effective, it is required to execute the
"SAVE" command and to restart before exiting the maintenance command.
COMMAND 1
MG-PRI > SET TCS_T1_3
4K Data Link
G.704 Mode
BOS/MOS Operation
Signaling A Logic-Recv( 0/1:1 ): 1
Signaling Pattern-Recv( 0-3:2 ): 2
Signaling A Logic-Send( 0/1:1 ): 1
Signaling Pattern-Send( 0-3:2 ): 2
set value is 0x00CC
setting complete.
In order to make a setup reflect, re-starting
is required after saving a configuration file
by SAVE command.
COMMAND 2
MG-PRI > SET TCS_T1_3 00CC
set value is 0x00CC
setting complete.
In order to make a setup reflect, re-starting
is required after saving a configuration file
by SAVE command.
[P1]
( 0/1:0 ): 0
( 0/1:0 ): 0
( 0-3:0 ): 0
VOL.2-989
P1-Specify a set value
0000-FFFF= Set value (default value: 00CC)
When P1 is omitted→COMMAND 1
When P1 and P2 are specified→COMMAND 2
<COMMAND 1>
1) Specify 4K Data Link
0=MOS (default)
1=BOS
2) Specify G.704 Mode
0=ITU-T G.704 (default)
1=JG.704
3) Specify BOS/MOS Operation
When 0 is specified for 4K Data Link:
0=Sending MOS Message periodically/
Receiving MOS Message
1=Sending Mark /Receiving MOS Message
2=Sending MOS Flag /Receiving MOS Message
3=Sending MOS Flag /Not Receiving MOS Message
When 1 is specified for 4K Data Link
-When 0 is specified for G.704 Mode:
0=Sending 7E, 7E /Receiving BOS Message
1=Sending FF, FF /Receiving BOS Message
2=Sending FF, 7E /Receiving BOS Message
3=Sending FF, FF /Not Receiving BOS Message
-When 1 is specified for G.704 Mode:
0=Sending 7E, 7E /Receiving BOS Message
1=Sending 00, 00 /Receiving BOS Message
2=Sending 00, 00 /Receiving BOS Message
3=Sending 00, 00 /Not Receiving BOS Message
4) Specify Signaling A Logic-Recovery
1 (fixed)
5) Specify Signaling Pattern Recovery
2 (fixed)
6) Enable/Disable Signaling A Logic Sending
1 (fixed)
7) Specify Signaling Pattern Sending
2 (fixed)
<COMMAND 2>
A command is executed, and the result is displayed.
MG-PRI/PRA