NEC Univerge sv8500 Manual page 1173

If rport parameter is in Via header of SIP request received by MG-BRI, SIP response will be transferred to
the originating port of SIP request. The rport parameter will be added to Via header of SIP request to be
transferred from MG-BRI.
19. SET SIPSV_IPADDRESS
Assign the IP address, port number, and host name of SIP server.
MG-BRI(SIP)> SET SIPSV_IPADDRESS
SIP Server (1-20): 1
IP Address: 10.41.1.150
Port Number: 5060
Is there the Host Name? [Y/N]: y
Host Name: SVR1.nec.com
SIP server setting succeeded.
In order to make a setup reflect. re-starting is
required after saving a configuration data
by SAVE command.
Up to 20 SIP servers can be set in a network.
Note:
Execute the "SAVE" command before finishing the maintenance command to reflect change.
Note:
About IP address of SIP server (Telephony Server), refer to "Registration Destination of IP Devices/Sta-
Note 1:
tions" in INTRODUCTION of Installation Manual.
20. SET SMOOTH_PAD
Assign the Smooth PAD
MG-BRI(SIP)> SET SMOOTH_PAD P1
Smooth PAD Mode setting succeeded.
In order to make a setup reflect. re-starting is
required after saving a configuration data
by SAVE command.
Execute the "SAVE" command before finishing the maintenance command to reflect change.
Note:
VOL.2-920
MG(BRI) [SCA-2BRIA/MG-2BRIA]
Enter the SIP server number. Up to 20 SIP
servers can be set in a network.
Enter the IP address of SIP server.
(Default: 0.0.0.0)
e.g. 10.41.1.150
Enter the port number of SIP server.
1024-65535 (Default: 5060)
Enter the SIP server's host name in full-
domain. (up to 63-byte of characters, .
(period) and - (hyphen) is available)
The result is shown.
Specify the mode
0: DSP Smooth PAD is not used
1: +2 dBm (default)
2: -5 dBm
3: -2 dBm
4: 0 dBm
5: -4 dBm
The result is shown.
Note 1