NEC Univerge sv8500 Manual page 1170

Specify this value as one of the conditions for MG Based Call Retention to determine that the call is re-
Note:
leased. The call will be determined released if RTP is not received exceeding the assigned timer value dur-
ing call retention.
Execute the "SAVE" command before finishing the maintenance command to reflect change.
Note:
15. SET SIGNALING_PORT_NO
Assign the port number to be used for PHI signaling.
SET SIGNALING_PORT_NO P1
MG-BRI(SIP)>
Signaling port number setting succeeded.
In order to make a setup reflect. re-starting is
required after saving a configuration data
by SAVE command.
Execute the "SAVE" command before finishing the maintenance command to reflect change.
Note:
16. SET SIGNALING_QOS
Assign the ToS value added to signaling (SIP server signaling) session.
SET SIGNALING_QOS
MG-BRI(SIP)>
QOS [I(IP PRECEDENC)/D(DIFFSERV): IP PRECEDENCE]: P1
• When P1=IP PRECEDENCE is specified:
QOS[I(IP PRECEDENCE)/D(DIFFSERV):I]:I
PRECEDENCE(0-7:6):6
DELAY(0/1:0):0
THROUGHPUT(0/1:0):0
RELIABILITY(0/1:0):0
COST(0/1:0):0
Signaling QoS setting succeeded.
In order to make a setup reflect. re-starting is
required after saving a configuration data
by SAVE command.
P1: I/D
I: IP Precedence type data assignment
D: DIFFSERV type data assignment
VOL.2-917
MG(BRI) [SCA-2BRIA/MG-2BRIA]
P1: Port number (1024-65535)
(default: 5060)
The result is shown.
I: When (IP PRECEDENCE) is selected
Precedence in IP network (0-7)
(6: Default)
Precedence of Low Delay in IP network
0: Not specified (Default)
1: Specified
Precedence of Throughput in IP network
0: Not specified (Default)
1: Specified
Precedence of Reliability in IP network
0: Not specified (Default)
1: Specified
Precedence of Lower Cost in IP network
0: Not specified (Default)
1: Specified
The result is shown.