NEC Univerge sv8500 Manual page 715

COMMAND No.
1 CAR_DETECT
2 CODEC_COEF_MG
3 DSP_ECFB_MG
4 DTMF_CUTOFF_TIME
5 EC_TRAINING_MG
6 FAXERRORDETECT_MG
7 FAXRECVPAD_MG
SET
(MG side)
8 FAXSENDPAD_MG
9 IC_ABANDON_TIME
10 NO_LOOP_TIME
11 RELEASE_SIGNAL
12 SMOOTH_PAD_MG
13 RVS_AUST
14 AUTO_POLARITY
The following SET commands are available for MCMG with the firmware versions: SP-3849 MCMG
Note:
PROG-A Issue 9 or later.
COMMAND No.
1 CALL_HOLD
SET
(MG side)
2 RTP_STOP_DETECT
SUB COMMAND
Setting CAR Detection:
Setting CODEC Coefficiency:
Setting DSP echo canceller for FAX communication
Setting DTMF Cutoff Timer:
Setting Training feature mode of echo canceller:
Setting FAX enable timer:
Setting Fax receiver PAD value:
Setting Fax sender PAD value:
Setting I/C call abandon timer:
Setting Loop Prohibition timer:
Setting Release Signal:
Setting DSP smooth PAD mode:
Setting RVS mode (for Australia):
Setting Auto Polarity
SUB COMMAND
Setting MG Based Call Retention
Setting RTP Receive Stop Detect timer used for MG Based
Call Retention
FUNCTION
FUNCTION
VOL.2-462
MCMG Card [SCA-7COTA]
REMARKS
REMARKS