NEC Univerge sv8500 Manual page 1021

11.7.6 List of Command Used for Configuration Data
SET: Command to assign the configuration data
Sub-command
1 DEFAULT_GATEWAY
2 DHCP
3 DRS_IPADDRESS
4 EXTERNAL_MUSIC_LEVEL
5 FAX_DETECTION_TIME
6 HC_RCV_TIMER
7 INTERFACE
8 LAN_ERROR_CHECK
9 OWN_IPADDRESS
10 SIGNALING_PORT_NO
11 SIGNALING_QOS
12 SMOOTH_PAD
13 PRE-NEGOTIATION_PORT_NO
14 RTP_START_PORT_NO
15 VLAN
16 WARNING_TONE_CONTROL
The following commands are available for MG-BRI with the firmware versions: SP-3709 BRI MG BSC
Note:
PROG-A Issue 18 or later and SP-3708 BRI BOOT PROG-A Issue 8 or later.
Sub-command
1 CALL_HOLD
2 RTP_STOP_DETECT
Assign the Default Gateway.
Assign whether to use DHCP Server or not.
Assign the IP Address and Port number of DRS. Only "Primary DRS"
needs to be assigned here.
Assign input impedance of the external hold tone interface.
Assign the effective switching time for FAX
Assign the Time-out value for Telephony Server health check waiting
process.
Assign the speed and activation mode of Ether controller.
Assign the interval to detect LAN cable fall-off
Assignment of IP Address and Subnet Mask of MG-BRI itself.
Assign the port number to be used for signaling toward PHI.
Assign the ToS value towards signaling (DRS) and H.245 Ready
Packet Session.
Assign the Smooth PAD
Assign the Port number to be used for sending/receiving H.245 Pre-
negotiation Packet.
Assign the Start number of Port to be used in RTP.
Assign the Tag VLAN information.
Assign whether to use warning tone when LAN failure or not.
Enable/Disable MG Based Call Retention.
Assign RTP Receive Stop Detect timer used for MG Based Call Re-
tention.
VOL.2-768
Function
Function
MG-BRI