NEC Univerge sv8500 Manual page 1156

REBOOT Command
This command is used to reboot the MG(BRI).
MG-BRI>reboot
Do you need reboot? [Y/N]: Y
[createRamDrb]New File System is Created
Attached TCP/IP interface to axDev unit 0
When configuration data has been modified, use REBOOT command after executing SAVE command. The
Note:
check message below appears whether to save or not save the modified data when SAVE command has not
been executed.
Configuration data was changed.
** Don't power off in progress**
y: Save and Exit
n: Exit without saving
c: Cancel
[y/n/c]: y
Configuration data has been saved.
finished!
Enter "Y" to execute the command.
Boot message will be displayed.
Enter "y" to save and execute rebooting.
VOL.2-903
MG(BRI) [SCA-2BRIA/MG-2BRIA]