NEC Univerge sv8500 Manual page 1020

Ordinary command executes one order at a line, but for some of the command, value needs to be entered
in dialogue format because some of the command cannot execute a order in a line. For example, some of
the Sub-command for "SET" Command value need to be assigned in hexadecimal. Parameter can be omit-
ted in this case. Setting value will be decided in hexadecimal when any value was assigned in dialogue for-
mat. Also, value can be entered directly by hexadecimal. Sample configuration is shown below.
<Sample Configuration of Dialogue format command entry>
MG-BRI>set signaling_qos
QOS[II(IP PRECEDENCE)/D(DIFFSERV):I]:I
PRECEDENCE(0-7: 6):6
DELAY(0/1): 0
THROUGHPUT(0/1: 0):0
RELIABILITY(0/1: 0):0
COST(0/1:0):0
Other displays are omitted here.
Note:
I: When (IP PRECEDENCE) was chosen.
Precedence in IP Network (0-7)
(6: Default)
Order to prioritize Delay within the IP Network
0: No order (Default)
1: Order
Order to prioritize Throughput within the IP Network
0: No order (Default)
1: Order
Order to prioritize Reliability within the IP Network
0: No order (Default)
1: Order
Order to prioritize Lower Cost within the IP Network
0: No order (Default)
1: Order
VOL.2-767
MG-BRI