NEC Univerge sv8500 Manual page 1172

to the originating IP address designated by the maddr parameter. The maddr parameter will not be added
to Via header of SIP request to be transferred from MG-BRI.
- 2: To be used for transmission.
Even if maddr parameter is in Via header of SIP request received by MG-BRI, SIP response will be trans-
ferred to the originating IP address of SIP request without using the maddr parameter. The maddr param-
eter will be added to the Via header of SIP request to be transferred from MG-BRI. In this case, specify own
IP address.
3: To be used for reception and transmission.
If maddr parameter is in Via header of SIP request received by MG-BRI, SIP response will be transferred
to the originating IP address designated by the maddr parameter. The maddr parameter will be added to
Via header of SIP request to be transferred from MG-BRI.
18. SET SIP_RPORT
Select the mode to use the rport parameter in Via header of SIP message or not.
MG-BRI(SIP)> SET SIP_RPORT
SIP rport setting succeeded.
In order to make a setup reflect. re-starting is
required after saving a configuration data
by SAVE command.
Execute the "SAVE" command before finishing the maintenance command to reflect change.
Note:
The rport parameter indicate that the destination of SIP response is the originating port of SIP request in
Note:
Via header of SIP message. MG-BRI will operate as follows depending on the setting.
- 0: Not to be used.
Even if rport parameter is in Via header of SIP request received by MG-BRI, SIP response will be trans-
ferred to the port number written in Via header of SIP request without using the rport parameter. The rport
parameter will not be added to Via header of SIP request to be transferred from MG-BRI.
- 1: To be used for reception.
If rport parameter is in Via header of SIP request received by MG-BRI, SIP response will be transferred to
the originating port of SIP request. The rport parameter will not be added to Via header of SIP request to
be transferred from MG-BRI.
- 2: To be used for transmission.
Even if rport parameter is in Via header of SIP request received by MG-BRI, SIP response will be trans-
ferred to the port number written in Via header of SIP request without using the rport parameter. The rport
parameter will be added to the Via header of SIP request to be transferred from MG-BRI.
3: To be used for reception and transmission.
P1
VOL.2-919
MG(BRI) [SCA-2BRIA/MG-2BRIA]
P1: Select the mode
Effective range: 0-3 (Default: 1)
0: Not to be use.
1: To be used for reception.
2: To be used for transmission.
3: To be used for reception and transmission.
The result is shown.