NEC Univerge sv8500 Manual page 1062

Do not connect LAN and ISDN line here. These cables are connected in Section 12.3 Startup MG(BRI) and
Note:
Basic Tests.
STEP 1: AC power cable connection
Connect the AC power cable to AC Power Inlet on the rear panel of 1U-MPC. Fix the AC power cable
with the stopper.
Connect the other end of the power cable to appropriate AC supply.
For the safety measures against static electricity, lightning strike, and other electrical surges, be sure to
Note:
make proper connection to grounding (less than 10
is struck by lightning directly, the lightning might cause damage to MG(BRI) and AC power cable without
Ground connection.
SCA-2BRIA
REAR
AC power cable stopper
MG-2BRIA
AC power cable stopper
VOL.2-809
MG(BRI) [SCA-2BRIA/MG-2BRIA]
PACT
connected to AC Power supply
connected to AC Power supply
Ω ). As MG(BRI) has ISDN interface, if the line cable