Table of Contents
Advertisement
48
Chapter 1 About Ethernet Switches 325 and 425
3
If you make an error when performing configurations in Step 2 that results in the
loss of switch connectivity (for example, an error in the IP address mask, MLT
configuration, or VLAN trunking), the
safeguard: when the reload timer expires, the switch reboots to the last saved
configuration, and connectivity is re-established. Therefore, you do not have to
travel to the remote site to reconfigure the switch.
For more information, see
show mac-address-table enhancement
The
parameters:
to filter the results of the command by displaying only those entries in the address
table that include or exclude the specified pattern. The value for <pattern> must
be a sequence of 1 to 6 bytes in hex, separated by dashes, for example:
show mac-address-table port 1/1-5 address
include 00-0E-45-23
For more information, see
restore factory-default command
The
to its default configuration.
The syntax for the
320985-A Rev 01
If the configurations cause no problems and switch connectivity is
maintained, you can perform the following:
a
Save the current running configuration using the
or
write mem,
b Since the new configuration is working properly, cancel the reload using
the
reload cancel
show mac-address-table
include/exclude <pattern>
restore factory-default
restore factory-default
command.
save config
command.
reload
"reload command" on page
CLI command provides the following new
. These new parameters allow you
"show mac-address-table command" on page
CLI command resets the switch or stack back
copy config nvram
command provides you with a
136.
command is:
,
144.
Hide quick links:
Advertisement
Table of Contents
