Configuring The Ip Manager List; Nortel Ethernet Routing Switch 2500 Series; Nn47215-505 (323165-B) 02.01 Standard; Show Ipmgr Command - Nortel 2526T Configuration

show password aging-time day command
The password aging-time day command shows the configured
password aging-time.
The syntax of the command is:
show password aging-time
The following shows a sample output for this command:
2550T (config)#show password aging-time
Aging time:
Configuring the number of password logon attempts
The telnet-access retry command configures the number of times a
user can attempt a password:.
The syntax of the command is:
telnet-access retry <number>
where <number> is an integer in the range 1-100 that specifies the allowed
number of failed logon attempts. The default is 3.
If a new aging time is set from the CLI, the password aging counters are
not reset.
Configuring the IP manager list
When enabled, the IP manager list determines which source IP addresses
are allowed access to the switch. No other source IP addresses have
access to the switch. You configure the IP manager list by using the
following commands:
•
•
•
•
•

show ipmgr command

The show ipmgr command displays whether Telnet, SNMP, and Web
access are enabled; whether the IP manager list is used to control access
to Telnet, SNMP, and the Web-based management system; and the current
IP manager list configuration. The syntax for the show ipmgr command is:
show ipmgr
Copyright © 2007, Nortel Networks
.
100 days
"show ipmgr command" (page 39)
"ipmgr command for management system" (page 40)
"no ipmgr command for management system" (page 41)
"ipmgr command for source IP address" (page 42)
"no ipmgr command for source IP address" (page 42)

Nortel Ethernet Routing Switch 2500 Series

Security — Configuration and Management

NN47215-505 (323165-B) 02.01 Standard

4.1 19 November 2007
Securing your system 39