CLI Main Menu or Setup
Once the Administrator user password is verified, you are given complete
access to the Nortel SNAS. If the Nortel SNAS is still set to its factory
default configuration, the system will run Setup (see
41)), a utility designed to help you through the first-time configuration
process. If the Nortel SNAS has already been configured, the Main menu
of the CLI is displayed instead.
Figure 22 "Administrator Main Menu" (page 383)
with administrator privileges.
Figure 22
Administrator Main Menu
Command line history and editing
For a description of global commands, shortcuts, and command line
editing functions, see
Idle timeout
The Nortel SNAS will disconnect your local console connection or
remote connection (Telnet or SSH) after 10 minutes of inactivity.
This value can be changed to a maximum value of 1 hour using the
/cfg/sys/adm/clitimeout command.
If you are automatically disconnected after the specified idle timeout
interval, any unapplied configuration changes are lost. Therefore, make
sure to save your configuration changes regularly by using the global
apply command.
If you have unapplied configuration changes when you use the global
exit command to log out from the CLI, you will be prompted to use the
global diff command to view the pending configuration changes. After
verifying the pending configuration changes, you can either apply the
changes or use the revert command to remove them.
Copyright © 2007, 2008 Nortel Networks
.
"CLI reference" (page
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Idle timeout 383
"Initial setup" (page
shows the Main menu
413).