Show Ip Icmp Client - Nortel Versalar 15000 Reference Manual

show ip icmp client

The output includes the following information:
Interface
Filter
State
Status
Prec
In/Out
Action
Hits
show ip icmp client
The
statistics about ICMP packets for all IP addresses or for a specific IP address. This
command allows for the following option:
<circuit_name>
The output includes the following information:
Circuit
IP Address
Echo Requests
Echo Replies
Timestamp Reqs
Timestamp Repls
Address Mask Requests
Address Mask Replies
78
show ip icmp client
IP interface.
Name of the filter.
Operational state of the filter: enabled or disabled.
Current status of the filter: active, error, or inactive.
Filter precedence. This is a metric used to compare this
access policy filter to other filters that a given route may
match. A filter with a higher precedence value will be
chosen over one with a smaller value. (Note that the
highest precedence value is 1 and the lowest is 64.)
Direction of traffic to which the filter is applied: in for
incoming or out for outgoing.
Determines whether the router accepts or drops the
packet if it matches all of a filter's match criteria. By
default, the action of each filter allows the router to accept
a packet if it matches.
Number of packets that matched the filter.
command displays echo, timestamp, and address mask
Displays information about the specified circuit only.
Name of the circuit associated with the IP interface.
IP address of the interface.
Number of ICMP echo request messages received.
Number of ICMP echo reply messages received.
Number of ICMP timestamp request messages received.
Number of ICMP timestamp reply messages received.
Number of ICMP address request messages received.
Number of ICMP address reply messages received.
308689-B Rev 00