Correcting The Images - Ricoh OR-C1 Field Service Manual

Correcting the Images

Correcting Skewed Images
1. Test pattern (Trimming Pattern) mode check
Is the image skewed?
No
2. Platen mode check
Set an original flush against the left and rear scales and make a copy.
Does the image come out as a parallelogram?
No
3. ADF mode check
Feed an original through the ADF.
Is the image skewed?
No
Yes
1. Adjust the side fences. There must be no gap between the fences and the
paper stack.
2. Adjust the paper registration: SP1-002 and 003.
Yes
Attach the Scanner Holder (a supporter that is normally attached during
shipping)
Yes
Do the front and rear transport
rollers feed the original
straight?
No
Do Procedure A below.
Image Problems
Yes
Change the position of the right
hinge screw to the longer hole,
and make small position
adjustments that are necessary.
6
329