Ricoh OR-C1 Field Service Manual page 222

4. Replacement and Adjustment
7. Lightly tap the top of the PCU [A] with a screwdriver at 8 locations. These locations must be at
equal intervals. Tap 2 or 3 times at each location, to make the toner fall into the development
4
section.
8. Install the PCU in the machine.
9. Turn on the main power switch, and close the front door. After the machine turns the development
roller for 10 seconds, go to the next step.
10. Open and close the door two more times. The total rotation time is 30 seconds.
11. If you replaced PCU components:
• If A4/8
• If A3/11" x 17" paper is installed, make 2 copies or prints.
• To make solid black prints, use SP2-109 No.8.
• This step is not necessary if only the developer was replaced.
220
" x11" paper is installed, make 4 copies or prints.
1/2