5. Remove the front screw [A] (
6. Remove the rear screws [B] (
7. Release the rear tab [C] then front tab [D], then separate the top and bottom.
• Be sure to release the rear tab first and the front tab second.
8. Open the developer pack [A].
9. While turning the black gear [B], slowly move the pack left and right and pour half of the
developer over the auger [C].
10. Continue to turn the black gear until the developer is level.
11. While continuing to turn the black gear, slowly move the pack left and right and pour the remaining
half of the developer over the auger until the developer is level.
x1)
x2)
Copier Installation
2
33