Ricoh OR-C1 Field Service Manual page 575

Job Spooling (Protocol)
This SP determines whether job spooling is enabled or disabled for each protocol. This is
a 8-bit setting.
[0 or 1 / 1 / 1 ]
0: No spooling, 1: Spooling enabled
69*
0 LPR
1 FTP (Not Used)
2 IPP
3 SMB
TELNET (0:OFF 1:ON)
Disables or enables Telnet operation. If this SP is disabled, the Telnet port is closed.
90*
[0 or 1 / 1 / 1 ]
0: Disable
1: Enable
Web (0:OFF 1:ON)
Disables or enables the Web operation.
91*
[0 or 1 / 1 / 1 ]
0: Disable
1: Enable
Active IPv6 Link Local Address
This is the IPv6 local address referenced on the Ethernet or wireless LAN (802.11) in the
format:
145
"Link-Local address" + "Prefix Length"
The IPv6 address consists of a total 128 bits configured in 8 blocks of 16 bits each.
These notations can be abbreviated. See "Note: IPV6 Addresses " below this table.
4 BMLinks (Japan Only)
5 DIPRINT
6 Reserved (Not Used)
7 Reserved (Not Used)
System SP Tables-5
4
217