Ricoh OR-C1 Field Service Manual page 508

4. Appendix: Service Program Mode Tables
3 Text/Photo: Multilevel Copy
4 Pale: Multilevel Copy
5 Generation: Multilevel Copy
Forced Toner Supply
Forces the toner bottle to supply toner to the toner supply unit.
Press Execute on the touch panel to start.
2908
During this process, the machine supplies toner until the toner concentration in the
development unit reaches a standard level. However, if the toner concentration does
4
not reach a standard level, the machine supplies toner for 2 minutes maximum.
Polygon Motor Idling Time
Selects the polygon motor idling time.
The polygon motor starts rotating up to its operation speed if the user 1) sets an
original, 2) touches a key, or 3) opens the platen cover or document feeder. This
shortens the time to the first copy. However, with the default (10 s) set, the motor stops
2915*
if the user does nothing for 10 s after doing one of the actions above, and stops 10 s at
the end of a job.
Note: If set at "0", the polygon motor never turns off during stand-by. However, when
the machine goes into energy saver mode, the polygon motor turns off regardless of
this timer.
1 Idling Time ADJ
2 Post Idling Time ADJ
Toner Supply Mode
Selects the toner supply mode.
2921*
[0 = Normal 1 / 1 = Normal 2 / 2 = Fixed 1 / 3 = Fixed 2]
Normally, only use setting 0. Change to 3 temporarily if the TD sensor is defective. Do
not use settings 1 and 2; these are for designer's use only.
150
[0 to 10 / 5 / 1 step]
[0 to 60/15/1]
[0 to 60/10/1]