Ricoh OR-C1 Field Service Manual page 443

No. Type
Finisher punch motor error (D589)
The punch HP sensor is not activated within the specified time after the punch
motor turned on. The 1st detection failure issues a jam error, and the 2nd failure
issues this SC code.
• Punch HP sensor harness loose, broken
• Punch motor harness loose, broken
• Punch motor obstructed
760 B
• Punch motor defective
• Punch HP sensor defective
1. Check the connections and cables for the punch motor and HP sensor.
2. Check for blockages in the punch motor mechanism.
3. Replace the punch motor harness.
4. Replace the punch HP sensor and/or punch motor
5. Replace the finisher main board.
No. Type
Folder plate motor error (D589)
The folder plate in the 1000-sheet booklet finisher moved but was not detected at
the home position within the prescribed time. The 1st detection failure issues a jam
error, and the 2nd failure issues this SC code.
• Folder plate motor drive obstructed
• Folder plate HP sensor harness loose, broken
• Folder plate motor harness loose, broken
761 B
• Folder plate motor defective
• Folder plate HP sensor defective
1. Check the connections and cables for the folder plate motor and HP sensor.
2. Check for blockages in the folder plate motor mechanism.
3. Replace the folder plate motor harness.
4. Replace the folder plate HP sensor and/or folder plate motor
5. Replace the finisher main board.
Details (Symptom, Possible Cause, Troubleshooting Procedures)
Details (Symptom, Possible Cause, Troubleshooting Procedures)
Service Call Conditions
3
85