Ricoh OR-C1 Field Service Manual page 507

2side:Lead Edge
Adjusts the voltage applied to the separation plate, during printing at the leading edge
3
of the paper on the rear side.
See SP2901 1.
[–4000 to 0 / –2100 / 100 V/step]
2side:Image Area
Adjusts the voltage applied to the separation plate, during printing at the image area of
4
the paper on the rear side.
See SP2901 2.
[–4000 to 0 / –2100 / 100 V/step]
Switching Timing Lead Edge
5
Adjusts the separation voltage switch timing based on FGATE assert.
[-20 to 20 / 15 / 1 mm]
2906* Tailing Control
Shift Range
Shifts the image across the page at the interval specified by SP2906 2.
When making many copies of an original that contains vertical lines (such as a table),
1
separation may not work correctly, then a tailing image will occur (ghosts of the vertical
lines will continue past the bottom of the table). This SP prevents this problem.
[0.0 to 1.0 / 0.0 / 0.1 mm/step]
Number of Sheets
2
Changes the interval for the image shift specified by SP2906 1.
[0 to 10 / 0 / 1 page/step]
Filter Setting
Adjusts the line width for the copy mode. The default setting disables this function. A
2907*
number smaller than the default makes lines thinner, a number larger than the default
makes lines thicker.
1 Text: Multilevel Copy
2 Photo: Multilevel Copy
System SP Tables-2
[0 to 10 / 6 / 1 step]
[0 to 10 / 5 / 1 step]
4
149