Ricoh OR-C1 Field Service Manual page 438

3. Appendix: Service Call Conditions
No. Type
723 B
3
No. Type
725 B
80
Details (Symptom, Possible Cause, Troubleshooting Procedures)
Feed-out belt motor error
The feed-out belt did not return to the home position within the prescribed time.
• Feed-out belt motor drive is obstructed (jammed paper, paper scraps, etc.)
• Motor harness loose or broken
• Feed-out belt HP sensor dirty, disconnected, broken
• Motor defective
1. Check the connections and cables for the components mentioned above.
2. Check for blockages in the feed-out belt motor mechanism.
3. Replace the feed-out belt HP sensor and/or feed-out motor.
4. Replace the finisher main board.
Details (Symptom, Possible Cause, Troubleshooting Procedures)
Finisher exit guide plate motor error
The exit guide plate HP sensor did not activate within the prescribed time after the
exit guide plate motor turned on.
• Finisher exit guide plate motor drive is obstructed (jammed paper, paper
scraps, etc.)
• Exit guide plate motor harness loose, broken
• Exit guide plate HP sensor harness loose, broken
• Exit guide plate motor defective
• Exit guide plate HP sensor defective
1. Check the connections and cables for the components mentioned above.
2. Check for blockages in the exit guide plate motor mechanism.
3. Replace the exit guide plate position sensor and/or exit guide plate motor.
4. Replace the finisher main board.