Ricoh OR-C1 Field Service Manual page 595

2 Switch to Print
3 Total Counter
Address Book Function Japan Only
The machine is shipped ready to use with a G3 line. Use this SP to switch all at once to
5850*
G4 after adding a G4 line. If the G4 line becomes unusable for some reason, you can
use this SP to switch easily back to G3. Just touch [Replacement].
Bluetooth
5851
Sets the operation mode for the Bluetooth Unit. Press either key.
[0: Public] [1: Private]
Stamp Data Download
Push [Execute] to download the fixed stamp data from the machine ROM onto the hard
disk. Then these stamps can be used by the system. If this is not done, the user will not
5853
have access to the fixed stamps ("Confidential", "Secret", etc.).
You must always execute this SP after replacing the HDD or after formatting the HDD.
Always switch the machine off and on after executing this SP.
5856 Remote ROM Update
When set to "1" allows reception of firmware data via the local port (IEEE 1284)
during a remote ROM update. This setting is reset to zero after the machine is cycled off
and on. Allows the technician to upgrade the firmware using a parallel cable
2
[0 or 1 / 0 / 1]
0: Not allowed
1: Allowed
5857* Save Debug Log
Determines whether the installation date is printed on the printout
for the total counter.
[0 or 1/ 1 / -]
0: OFF (No Print)
1: ON (Print)
-
System SP Tables-5
4
237