Configuring Gigabit Ethernet Interfaces (J-Web Procedure) - Juniper EX2200 Hardware Manual

Configuring Gigabit Ethernet Interfaces (J-Web Procedure)

Copyright © 2015, Juniper Networks, Inc.
show interfaces ge- on page 276
show interfaces xe- on page 307
Understanding Interface Naming Conventions on EX Series Switches on page 6
You can configure specific properties on your Ethernet interface to ensure optimal
performance of your network in a high-traffic environment.
To configure properties on a Gigabit Ethernet interface, a 10-Gigabit Ethernet interface,
and a 40-Gigabit Ethernet interface on an EX Series switch:
Select >
1. Interfaces Ports
The page that is displayed lists Gigabit Ethernet, 10-Gigabit Ethernet interfaces, and
40-Gigabit Ethernet interfaces, and their link statuses.
NOTE: After you make changes to the configuration on this page, you
must commit the changes immediately for them to take effect. To commit
all changes to the active configuration, select
See Using the Commit Options to Commit Configuration Changes (J-Web
Procedure) for details about all commit options.
Select the interface you want to configure. For an EX8200 Virtual Chassis configuration,
2.
select the member and the FPC slot if the interface you want to configure is not listed
under in the top table on the page.
Ports
Details for the selected interface, such as administrative status, link status, speed,
duplex, and flow control, are displayed in the
NOTE: You can select multiple interfaces and modify their settings at the
same time. However, while doing this, you cannot modify the IP address
or enable or disable the administrative status of the selected interfaces.
NOTE: In the J-Web interface, you cannot configure interface ranges and
interface groups.
Click and select the set of options you want to configure first:
Edit
3.
.
Details of port
Chapter 2: Configuration Tasks
>
Commit Options Commit
table on the page.
35
.