Configuring The Interface Address - Juniper EX2200 Hardware Manual

Network Interfaces for EX4300 Switches

Configuring the Interface Address

48
Ethernet Interfaces Overview
EX Series Switches Interfaces Overview on page 3
Ethernet Interfaces
You assign an address to an interface by specifying the address when configuring the
protocol family. For the
inet
iso family, configure one or more addresses for the loopback interface. For the
, ,
ethernet-switching tcc mpls
NOTE: The point-to-point (PPP) address is taken from the loopback interface
address that has the primary attribute. When the loopback interface is
configured as an unnumbered interface, it takes the primary address from
the donor interface.
To assign an address to an interface, include the
address address {
broadcast address;
destination address;
destination-profile name;
eui-64;
preferred;
primary;
}
You can include these statements at the following hierarchy levels:
[edit interfaces interface-name unit logical-unit-number family family]
[edit logical-systems logical-system-name interfaces interface-name unit
logical-unit-number family family]
In the statement, specify the network address of the interface.
address
For each address, you can optionally configure one or more of the following:
Broadcast address for the interface subnet—Specify this in the
this applies only to Ethernet interfaces, such as the management interface
or me0 the Fast Ethernet interface, and the Gigabit Ethernet interface.
Address of the remote side of the connection (for point-to-point interfaces
only)—Specify this in the
PPP properties to the remote end—Specify this in the
You define the profile at the
point-to-point interfaces only).
or family, configure the interface IP address. For the
inet6
, , and families, you never configure an address.
tnp vpls
address
statement.
destination
[edit access group-profile name ppp]
ccc
statement:
statement;
broadcast
fxp0
destination-profile statement.
hierarchy level (for
Copyright © 2015, Juniper Networks, Inc.
,
, ,
em0