Juniper EX2200 Hardware Manual page 301

Table 48: show interfaces ge- Output Fields (continued)
Field Name Field Description
Information about link autonegotiation:
Autonegotiation
information
Negotiation status:
Complete
Ethernet interfaces was successful.
Incomplete
configured or does not perform autonegotiation.
No autonegotiation
and the link mode and speed are manually configured.
Link partner
Link mode
either
cannot be determined, the value is
Flow control
device. For Gigabit Ethernet interfaces, the types are:
partner supports
supports
supports
Remote fault
indicates a receive link error.
Negotiation error
link partner is going offline.
Link partner speed
Local resolution
interface:
Flow control
Gigabit Ethernet interfaces, the types are:
PAUSE
on transmit); and
on both receive and transmit or
Link mode
Displayed when
Local link speed
status
Remote fault
receive),
detected on receive).
Packet Forwarding Information about the configuration of the Packet Forwarding Engine:
Engine
Destination slot
configuration
On standalone switches with built-in interfaces, the slot number refers to
the switch itself and is always 0.
On Virtual Chassis composed of switches with built-in interfaces, the slot
number refers to the member ID of the switch.
On switches with line cards or on Virtual Chassis composed of switches
with line cards, the slot number refers to the line card slot number on the
switch or Virtual Chassis.
Logical Interface
Copyright © 2015, Juniper Networks, Inc.
—The autonegotiation process between the local and remote
—Remote Ethernet interface has the speed or link mode
—Local Ethernet interface has autonegotiation disabled
—Information from the link partner:
—Depending on the capability of the attached Ethernet device,
Full-duplex or Half-duplex . If the link mode of the remote device
Unknown
—Types of flow control supported by the remote Ethernet
on receive and transmit);
PAUSE
on transmit); and
PAUSE Symmetric/Asymmetric
on both receive and transmit or
PAUSE
—Remote fault information from the link partner—
indicates that the link partner is receiving.
OK
indicates a negotiation error.
—Speed of the link partner.
—Resolution of the autonegotiation process on the local
—Type of flow control that is used by the local interface. For
on receive and transmit);
Asymmetric
Symmetric/Asymmetric
PAUSE
—Link mode of local interface: either
Negotiation status is
—Speed of the local interface. Displayed when
is Incomplete .
—Remote fault information.
Offline (local interface is offline), and
—FPC slot number:
.
(link
Symmetric
(link partner
Asymmetric
(link partner
only on receive).
PAUSE
Failure
indicates that the
Offline
(link partner supports
Symmetric
(link partner supports
(link partner supports
PAUSE
only on receive).
or
Full-duplex Half-duplex
Incomplete .
Negotiation
(no error detected on
Link OK
Link Failure (link error
Chapter 5: Operational Commands
Level of Output
extensive
PAUSE
.
extensive
281