Connecting And Configuring An Ex Series Switch (J-Web Procedure) - Juniper EX3200 Series Complete Hardware Manual

Related Topics

Connecting and Configuring an EX Series Switch (J-Web Procedure)

Copyright © 2010, Juniper Networks, Inc.
The configured parameters are displayed. Enter
The configuration is committed as the active configuration for the switch. You can now
log in with the CLI or the J-Web interface to continue configuring the switch. If you use
the J-Web interface to continue configuring the switch, the Web session is redirected to
the new management IP address. If the connection cannot be made, the J-Web interface
displays instructions for starting a J-Web session.
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 167
Installing and Connecting an EX2200 Switch
Installing and Connecting an EX3200 or EX4200 Switch on page 117
Installing and Connecting an EX4500 Switch
Installing and Connecting an EX8208 Switch
Installing and Connecting an EX8216 Switch
There are two ways to connect and configure an EX Series switch: one method is through
the console using the CLI and the other is using the J-Web interface. This topic describes
the J-Web procedure.
NOTE: Before you begin the configuration, enable a DHCP client on the management
PC you will connect to the switch so that the switch can obtain an IP address
dynamically.
NOTE: Read the following steps before you begin the configuration. You must complete
the initial configuration using EZSetup within 10 minutes. The switch exits EZSetup
after 10 minutes and reverts to the factory default configuration, and the PC loses
connectivity to the switch.
EX2200 switch—The LEDs on the network ports on the front panel blink when the
switch is in the initial setup mode.
EX3200, EX4200, EX4500, or EX8200 switch—The LCD displays a count-down timer
when the switch is in initial setup mode.
Chapter 12: Performing Initial Configuration
to commit the configuration.
yes
167