Show Interfaces Xe - Juniper EX2200 Hardware Manual

show interfaces xe-

Syntax
Release Information
Description
Options
Required Privilege
Level
Related
Documentation
Copyright © 2015, Juniper Networks, Inc.
show interfaces xe-fpc/pic/port
<brief | detail | extensive | terse>
<media>
<statistics>
Command introduced in Junos OS Release 9.0 for EX Series switches.
Display status information about the specified 10-Gigabit Ethernet interface.
NOTE: You must have a transceiver plugged into an SFP+ or an XFP port
before information about the interface can be displayed.
NOTE: On an EX Series switch, the traffic statistics for a LAG might vary
slightly from the cumulative traffic statistics of the member interfaces of the
LAG. This difference is more likely to be seen when the traffic is bursty in
nature, and because the statistics are not fetched from the LAG and the
members in the same instant. For accurate traffic statistics for a LAG, use
the aggregated Ethernet counters.
—Display standard information about the specified 10-Gigabit Ethernet
xe-fpc/pic/port
interface.
brief | detail | extensive | terse
—(Optional) Display media-specific information about network interfaces. For
media
10-Gigabit Ethernet interfaces, using the
new or additional information. The output is the same as when the
not used.
statistics —(Optional) Display static interface statistics. For 10-Gigabit Ethernet interfaces,
using the option does not provide you with new or additional information.
statistics
The output is the same as when the
view
Monitoring Interface Status and Traffic on page 233
Troubleshooting Network Interfaces on EX3200 Switches
Troubleshooting Network Interfaces on EX4200 Switches
Troubleshooting an Aggregated Ethernet Interface on page 329
Junos OS Ethernet Interfaces Configuration Guide
—(Optional) Display the specified level of output.
media option does not provide you with
option is not used.
statistics
Chapter 5: Operational Commands
option is
media
307