Connecting And Configuring An Ex Series Switch (J-Web Procedure) - Juniper EX4500 Hardware Manual

9. The configured parameters are displayed. Enter yes to commit the configuration. The configuration is
committed as the active configuration for the switch.
10. (For EX4500 switches only) Enter the operational mode command request chassis pic-mode intraconnect
to set the PIC mode to intraconnect.
You can now log in with the CLI or the J-Web interface to continue configuring the switch. If you use the
J-Web interface to continue configuring the switch, the Web session is redirected to the new management
IP address. If the connection cannot be made, the J-Web interface displays instructions for starting a
J-Web session.
SEE ALSO

Connecting and Configuring an EX Series Switch (J-Web Procedure) | 153

Installing and Connecting an EX2200 Switch
Installing and Connecting an EX2300 Switch
Installing and Connecting an EX3200 Switch
Installing and Connecting an EX3300 Switch
Installing and Connecting an EX3400 Switch
Installing and Connecting an EX4200 Switch
Installing and Connecting an EX4300 Switch
Installing and Connecting an EX4550 Switch
Installing and Connecting an EX4500 Switch | 114
Installing and Connecting an EX6210 Switch
Installing and Connecting an EX8208 Switch
Installing and Connecting an EX8216 Switch
Connecting and Configuring an EX Series Switch (J-Web Procedure)
There are two ways to connect and configure an EX Series switch: one method is through the console by
using the CLI and the other is by using the J-Web interface.
Starting in Junos OS Release 19.2R1, J-Web supports EX4650 switches.
153