Verifying That Lacp Is Configured Correctly And Bundle Members Are Exchanging Lacp Protocol Packets; Verifying The Lacp Setup; Verifying That Lacp Packets Are Being Exchanged - Juniper EX2200 Hardware Manual

Related
Documentation
Verifying That LACP Is Configured Correctly and Bundle Members Are Exchanging
LACP Protocol Packets

Verifying the LACP Setup

Purpose
Action
Meaning

Verifying That LACP Packets Are Being Exchanged

Purpose
Copyright © 2015, Juniper Networks, Inc.
NOTE: The Power Used
switches.
On an EX4300 switch, if you compare the values in the
field before and after enabling EEE, you will notice that power is saved when EEE is
enabled.
Configuring Energy Efficient Ethernet on Interfaces (CLI Procedure) on page 93
Understanding How Energy Efficient Ethernet Reduces Power Consumption on
Interfaces on page 16
Verify that LACP has been set up correctly and that the bundle members are transmitting
LACP protocol packets.
Verifying the LACP Setup on page 237
1.
Verifying That LACP Packets Are Being Exchanged on page 237
2.
Verify that the LACP has been set up correctly.
To verify that LACP has been enabled as active on one end:
user@switch> show lacp interfaces xe-0/1/0
Aggregated interface: ae0
LACP state: Role
xe-0/1/0 Actor
xe-0/1/0 Partner
LACP protocol: Receive State
xe-0/1/0
This ouput shows that LACP has been configured with one side as active and the other
as passive. When LACP is enabled, at least one side must be set as active for the bundled
link to be up.
Verify that LACP packets are being exchanged between interfaces.
field is displayed in the output only for EX6210
Exp Def Dist Col
No Yes No No
No Yes No No
Transmit State
Defaulted Fast periodic
Chapter 4: Routine Monitoring
Non-PoE power being consumed
Syn Aggr Timeout Activity
No Yes Fast Active
No Yes Fast Passive
Mux State
Detached
237