Juniper EX2200 Hardware Manual page 58

Network Interfaces for EX4300 Switches
Table 11: Port Edit Options (continued)
Field Function
Routed Uplink Applies the routed uplink role.
The interface family is set to
recommended CoS parameters are set for
schedulers and classifiers. See
for more CoS information.
Layer 2 Uplink Applies the Layer 2 uplink role.
The interface family is set to
port mode is set to
point-to-point
configured for port security.
None Specifies that no port role is configured for the
selected interface.
NOTE: For an EX8200 switch, dynamic ARP inspection and DHCP snooping parameters are not configured.
VLAN Options
38
, and
inet
Table 12 on page 40
ethernet-switching
, RSTP is enabled with the
trunk
option, and trusted DHCP is
Your Action
To specify an IPv4 address:
1. Select the
IPv4 address
2. Type an IP address—for example: 10.10.10.10.
3. Enter the subnet mask or address prefix. For example,
24 bits represents 255.255.255.0.
4. Click .
OK
To specify an IPv6 address:
1. Select the
IPv6 address
2. Type an IP address—for example:
2001:ab8:85a3::8a2e:370:7334.
3. Enter the subnet mask or address prefix.
4. Click .
OK
NOTE: IPv6 is not supported on EX2200 VC switches.
1. For this port role, you can select a VLAN member and
associate a native VLAN with the interface.
,
2. Click to view CLI commands for this role.
Details
3. Click .
OK
Copyright © 2015, Juniper Networks, Inc.
check box.
check box.