Verifying Ip Directed Broadcast Status - Juniper EX2200 Hardware Manual

Meaning
Related
Documentation

Verifying IP Directed Broadcast Status

Purpose
Action
Related
Documentation
Copyright © 2015, Juniper Networks, Inc.
Input bytes :
Output bytes :
Input packets:
Output packets:
Transit statistics:
Input bytes :
Output bytes :
Input packets:
Output packets:
IPv6 transit statistics:
Input bytes :
Output bytes :
Input packets:
Output packets:
Protocol inet, Generation: 144, Route table: 0
Flags: uRPF
Addresses, Flags: Is-Preferred Is-Primary
The show interfaces ge-1/0/10 extensive
command) displays in-depth information about the interface. The
detail
field near the bottom of the display reports the unicast RPF status. If unicast RPF has
not been enabled, the
uRPF
On EX3200, EX4200, and EX4300 switches, unicast RPF is implicitly enabled on all
switch interfaces, including aggregated Ethernet interfaces (also referred to as link
aggregation groups or LAGs), integrated routing and bridging (IRB) interfaces, and routed
VLAN interfaces (RVIs) when you enable unicast RPF on a single interface. However, the
unicast RPF status is shown as enabled only on interfaces for which you have explicitly
configured unicast RPF. Thus, the
have not explicitly configured unicast RPF even though unicast RPF is implicitly enabled
on all interfaces on EX3200 and EX4200 switches.
show interfaces xe- on page 307
Example: Configuring Unicast RPF on an EX Series Switch
Configuring Unicast RPF (CLI Procedure) on page 97
Disabling Unicast RPF (CLI Procedure) on page 99
Troubleshooting Unicast RPF on page 331
Verify that IP directed broadcast is enabled and is working on the subnet.
Use the show vlans extensive
and working on the subnet as shown in Example: Configuring IP Directed Broadcast on an
EX Series Switch.
Configuring IP Directed Broadcast (CLI Procedure)
Configuring IP Directed Broadcast (CLI Procedure) on page 100
0
0
0
0
0
0
0
0
0
0
0
0
command (and the
flag is not displayed.
flag is not displayed on interfaces for which you
uRPF
command to verify that IP directed broadcast is enabled
Chapter 4: Routine Monitoring
0 bps
0 bps
0 pps
0 pps
show interfaces ge-1/0/10
output
Flags:
241