[Edit Chassis] Configuration Statement Hierarchy On Ex Series Switches; Supported Statements In The [Edit Chassis] Hierarchy Level - Juniper EX2200 Hardware Manual

[edit chassis] Configuration Statement Hierarchy on EX Series Switches

Supported Statements in the [edit chassis] Hierarchy Level

Copyright © 2015, Juniper Networks, Inc.
periodic on page 215
preferred on page 216
primary (Address on Interface) on page 217
proxy-arp on page 218
rpf-check on page 219
speed (Ethernet) on page 220
traceoptions (Individual Interfaces) on page 221
traceoptions (Interface Process) on page 223
transmit-interval (Liveness Detection) on page 224
traps on page 225
unit on page 226
vlan (802.1Q Tagging) on page 227
vlan-id (VLAN Tagging and Layer 3 Subinterfaces) on page 228
vlan-tagging on page 229
This topic lists supported and unsupported configuration statements in the
hierarchy level on EX Series switches.
Supported statements are those that you can use to configure some aspect of a
software feature on the switch.
Unsupported statements are those that appear in the command-line interface (CLI)
on the switch, but that have no effect on switch operation if you configure them
Not all features are supported on all switch platforms. For detailed information about
feature support on specific EX Series switch platforms, see EX Series Switch Software
Features Overview.
This topic lists:
Supported Statements in the [edit chassis] Hierarchy Level on page 105
The following hierarchy shows the
EX Series switches:
chassis {
aggregated-devices {
ethernet {
device-count number;
lacp {
link-protection non-revertive;
system-priority system-priority-number
}
}
}
Chapter 3: Configuration Statements
configuration statements supported on
[edit chassis]
[edit chassis]
105