Juniper EX2200 Hardware Manual page 45

Copyright © 2015, Juniper Networks, Inc.
interfaces on Juniper Networks EX Series Ethernet Switches. The configurations common
to all the interfaces can be included in the interface range definition.
The interface range definition contains the name of the interface range defined, the
names of the individual member interfaces that do not fall in a series of interfaces, a
range of interfaces defined in the member range, and the configuration statements
common to all the interfaces. An interface range defined with member ranges and
individual members but without any common configurations, is also a valid definition.
NOTE: The interface range definition is supported only for Gigabit, 10-Gigabit,
40-Gigabit, and Fast Ethernet interfaces.
The common configurations defined in the interface range will be overridden by the local
configuration.
The defined interface ranges can be used at places where the
the following configuration hierarchies:
forwarding-options analyzer name input egress interface
forwarding-options analyzer name input ingress interface
poe interface
protocols dot1x authenticator interface
protocols igmp interface
protocols isis interface
protocols layer2-control bpdu-block interface
protocols link-management peer name lmp-control-channel
protocols link-management te-link name interface
protocols lldp interface
protocols lldp-med interface
protocols mstp interface
protocols oam ethernet link-fault-management interface
protocols ospf area area-id interface
protocols pim interface
protocols router-advertisement interface
protocols router-discovery interface
protocols rsvp interface
protocols sflow interfaces
protocols vstp vlan vlan-id interface
Chapter 1: Interfaces Overview
node is used in
interface
25