Configuring Aggregated Ethernet Interfaces (J-Web Procedure) - Juniper EX2200 Hardware Manual

Configuring Aggregated Ethernet Interfaces (J-Web Procedure)

Copyright © 2015, Juniper Networks, Inc.
Verifying the Status of a LAG Interface on page 234
Understanding Aggregated Ethernet Interfaces and LACP on page 8
Use the link aggregation feature to aggregate one or more Ethernet interfaces to form a
virtual link or link aggregation group (LAG) on an EX Series switch. The MAC client can
treat this virtual link as if it were a single link. Link aggregation increases bandwidth,
provides graceful degradation as failure occurs, and increases availability. You can use
the J-Web interface to configure aggregated Ethernet interfaces, or a LAG, on the switch.
NOTE: Interfaces that are already configured with MTU, duplex, flow control,
or logical interfaces are listed but are not available for aggregation.
To configure an aggregated Ethernet interface (also referred to as a LAG):
Select Configure > Interfaces
1.
The list of aggregated interfaces is displayed.
NOTE: After you make changes to the configuration on this page, you
must commit the changes immediately for them to take effect. To commit
all changes to the active configuration, select
See Using the Commit Options to Commit Configuration Changes for
details about all commit options.
Click one of the following:
2.
—Creates an aggregated Ethernet interface, or LAG. Enter information as
Add
specified in Table 28 on page
Edit —Modifies a selected LAG.
—Modifies settings for the selected LAG. Enter information as specified
Aggregation
in Table 28 on page
—Specifies VLAN options for the selected LAG. Enter information as specified
VLAN
in Table 29 on page
—Specifies IP options for the selected LAG. Enter information as specified
IP Option
in Table 30 on page
Delete —Deletes the selected LAG.
or
Disable Port Enable Port
selected interface.
Device Count —Configures the number of aggregated logical devices available to
the switch. Select the number and click
> Link Aggregation .
84.
84.
85.
85.
—Disables or enables the administrative status on the
.
OK
Chapter 2: Configuration Tasks
>
Commit Options Commit
83
.