Configuring Interface Ranges - Juniper EX2200 Hardware Manual

Configuring Interface Ranges

Example: Specifying an
Interface Range
Member Range
Example: Specifying an
Interface Range
Member
Copyright © 2015, Juniper Networks, Inc.
To configure an interface range, include the
hierarchy level.
interfaces]
The statement accepts only physical networking interface names in its
interface-range
definition.
Interfaces can be grouped either as a range of interfaces or using a number range under
the statement definition.
interface-range
Interfaces in an interface-range
individual members or multiple members using a number range.
To specify a member range, use the
interface-range name] hierarchy level.
To specify interfaces in lexical order, use the
statement.
A range for a member statement must contain the following:
—All, specifies sequential interfaces from 0 through 47.
*
CAUTION: The wildcard
account the interface numbers supported by a specific interface type.
Irrespective of the interface type,
from 0 through 47 to the interface group. Therefore, use
statement with caution.
num —Number; specifies one specific interface by its number.
—Numbers between low to high; specifies a range of sequential interfaces.
[low-high]
[num1, num2, num3] —Numbers
interfaces.
member-range ge-0/0/0 to ge-4/0/40;
To specify one or multiple members, use the
hierarchy level.
interface-range name]
To specify the list of interface range members individually or for multiple interfaces using
regex, use the member list of interface names
member ge-0/0/0;
member ge-0/*/*
member ge-0/[1-10]/0;
member ge-0/[1,2,3]/3;
interface-range
definition can be added as part of a member range or as
statement at the
member-range
member-range start-range to end-range
* in a member statement does not take into
includes interface numbers ranging
*
num1 , num2 , and num3
statement at the
member
statement.
Chapter 2: Configuration Tasks
statement at the [edit
[edit interfaces
* in a member
specify multiple specific
[edit interfaces
67